info@farmerboyag.com
1-800-845-3374
$35.63
Write a Review
STENNER PUMP® S128 Medicator Pump, 10 oz/min up to 60 psi Maximum, 60 psi
$776.27
In Stock
$776.27
DETAILS
The S128 is designed to automatically inject solution into the water line proportional to the system water flow at a ratio of 1 ounce of solution to 128 ounces of process water. Activated by a dry contacting pulse water meter, the pump automatically adjusts to the water flow.
As the pump registers dry contacts, it delivers the precise ratio. The pump has three speeds to automatically adjust the injection rate when the water system flow rate increases or decreases. This flow response design allows the pump to evenly and proportionally inject solutions especially at low system flow rates.
The S128 and the low flow VPD water meter are ideal for early stage poultry flocks and swine nurseries when water flow is minimal.
The pump's relays allow use of an existing water meter and controller. Injecting undiluted chemicals directly into the water line eliminates water restriction and the daily mixing of stock solutions. In addition, the pump is unaffected by poor water quality.
- Built-in signalrRepeater relay: The built-in signal repeater relay allows an existing water meter to activate the pump and register water consumption with the house controller
- Tube change timer-set the tube change timer DIP switches with the number of hours you want the pump to run before the LED is activated. When the set time is reached the change/level LED is lit solid red
- Leak detect setting & relay-set the pump's DIP switch to stop or to continue to run when a leak is detected. Set the optional output relay to notify another device if a leak occurs
- Potentiometer: Prime, 1 PPG, 1 PPL, 10 PPG, Reset Tube Timer, Standby
- Output relays: Signal repeater leak detect, Drive fault, Low level
- LED Indicators: Leak/fault, overrun, change/level, power/standby
- 10 OZ/MIN UP TO 60 PSI Maximum
SPECIFICATIONS
| Brand | STENNER PUMP® |
| Manufacturer Name | STENNER PUMP® |
| Motor Voltage (Amp Draw) | 120V 60Hz 1PH (0.6) |
| Cord Length | 6 Ft |
| Classification | Indoor / Outdoor |
| Flow Rate Output Control | Potentiometer |
| Max Working Pressure | 60 psi (4.1 bar) |
| Shaft ROM (Average Maximum) | 45 |
| Motor Type | Brushless DC Motor |
| Pump Tube | Santoprene (FDA Approved) |
| Flow Rate | 10 GPM |
SPECIFICATIONS
| Brand | STENNER PUMP® |
| Manufacturer Name | STENNER PUMP® |
| Motor Voltage (Amp Draw) | 120V 60Hz 1PH (0.6) |
| Cord Length | 6 Ft |
| Classification | Indoor / Outdoor |
| Flow Rate Output Control | Potentiometer |
| Max Working Pressure | 60 psi (4.1 bar) |
| Shaft ROM (Average Maximum) | 45 |
| Motor Type | Brushless DC Motor |
| Pump Tube | Santoprene (FDA Approved) |
| Flow Rate | 10 GPM |
